Yamaha Motorcyes . org - Yamaha Motorcycle Information

2005 Yamaha PW80 Pictures & Specs

2005 Yamaha PW80 Pictures & Specs

Yamaha PW80 Specifications

  • Yamaha PW80 MSRP: $1,249
  • Yamaha PW80 Engine:
  • Type: 79cc, air-cooled, case reed-inducted, 2-stroke
  • Bore x Stroke: 47 x 45.6mm
  • Compression Ratio: 6.6:1
  • Carburetion: 15mm Mikuni
  • Ignition: CDI
  • Transmission: 3-speed w/automatic clutch
  • Final Drive: Chain

  • Yamaha PW80 Chassis:
  • Suspension/Front: Telescopic fork; 4.3″ travel
  • Suspension/Rear: Single shock; 3.7″ travel
  • Brakes/Front: 95mm Drum
  • Brakes/Rear: 110mm Drum
  • Tires/Front: 2.50-14
  • Tires/Rear: 3.00-12
  • Yamaha PW80 Dimensions:
  • Length: 60.6″
  • Width: 25.2″
  • Height: 34.6″
  • Wheelbase: 41.5″
  • Seat Height: 25″
  • Ground Clearance: 7.3″
  • Dry Weight: 126 Lbs.
  • Fuel Capacity: 1.3 Gallons
  • Yamaha PW80 Other:
  • Color: Team Yamaha Blue/White
  • Warranty: 90 Day (Limited Factory Warranty)
No comments currently exist for this post.
Leave a Reply:

Latest Comments Sponsors
Sponsor Links
link arrows
Yamaha Motorcycle Archives RSS Yamaha ATV Forums
  • 96 big bear 350 4x4
    so I just picked up this quad for cheap and the only thing it needs is a seal for the front drive shaft and other then pulling off the shaft what...
    I have a white brothers four stroke exhaust slip on muffler that i want to trade for stock. Also interested in purchasing back rack. It is a 2000. […]
  • wtb stock exhaust 2000 warrior
    I have a White Brothers R4 on my warrior and am looking to go back to stock exhaust.
RSS Yamaha Rhino Forums
  • Wet Clutch Delete
    Looking at the wet clutch delete by airdam. Im wondering if anyone has ever ran one. I ride mostly hill climbs with big rocks, but im wanting to go...
  • wheel bearings/ offset
    I have the factory spacers on the back and my wheels are 5+2 offset. With this combination will the wheels bearing wear out faster?
  • WTB stock polished SE rims/tires
    Would like a set of stock rims for 08 700. I live on the VA/NC state line. […]
RSS Yamaha Grizzly Forums
  • Iron Baltic Skid Plate first ride
    Installing The install went pretty well except I had to use some longer screws for the front of the bash plate. Everything fit very well and the... […]
  • stator/regulator testing
    So, not to muddy sniper7's thread, I wanted to start my own as I do have specific questions because yes, I seem to be another that is having a...
  • Bump Starting the Grizzly 700
    My brother in law and I were wondering if it was possible to bump-start the fuel injected Grizzly. Before loading it up at the end of the weekend we...