Yamaha Motorcyes . org - Yamaha Motorcycle Information

2006 Yamaha Blaster Pictures & Specs

2006 Yamaha Blaster Pictures & Specs

Yamaha Blaster Specifications

  • Yamaha Blaster MSRP: $3,299 – $3,549 (Special Edition)
  • Yamaha Blaster Engine:
  • Type: 195cc, 2-Stroke Single, Air Cooled, Reed Valve
  • Bore x Stroke: 66mm x 57mm
  • Compression Ratio: 6.6:1
  • Carburetion: Mikuni 26mm
  • Ignition: CDI
  • Starting System: Kick
  • Transmission: 6-Speed Manual Clutch
  • Drive Train: 2WD; Sealed O-Ring Chain

  • Yamaha Blaster Chassis:
  • Suspension/Front: Independent Double Wishbone, 7.1″ w/ 5-way Preload Adjustment
  • Suspension/Rear: Swing Arm, 7.1″ and Threaded Preload Adjustment
  • Brakes/Front: Dual Hydraulic Disc
  • Brakes/Rear: Hydraulic Disc
  • Tires/Front: AT21 x 7-10
  • Tires/Rear: AT21 x 10-8
  • Yamaha Blaster Dimensions:
  • L x W x H: 68.3″ x 40.7″ x 40.9″
  • Seat Height: 29.1″
  • Wheelbase: 43.3″
  • Ground Clearance: 4.7″
  • Fuel Capacity: 2.4 Gallons
  • Dry Weight: 324 Lbs.
  • Yamaha Blaster Other:
  • Lighting: 35W Halogen Multi-reflector Headlight & 21/5W Brake light
  • Warranty: 6 Month (Limited Factory Warranty)
No comments currently exist for this post.
Leave a Reply:

Latest Comments Sponsors
Sponsor Links
link arrows
Yamaha Motorcycle Archives RSS Yamaha ATV Forums
RSS Yamaha Rhino Forums
  • installed a dynatek cdi now running very hot.
    can i get some help on why my 2006 rhino 660 is running so hot after putting the dynatek cdi box on? also my belt broke wondering if that had...
  • thought you would enjoy this pic
    bought this rhino to be a good worker.last week we had a trail clean up day and i mowed with the dr brush mower for about 4 hours strait then had to...
  • Selling 2008 Rhino
    I'm selling my one owner 2008 Rhino 700. I am the only driver of this machine. It has a little over 1400 miles and over 220 hours on it. Here is a...
RSS Yamaha Grizzly Forums
  • Good weekend at Attica IN Badlands
    We rode at the Badlands in Attica IN this weekend. I put my new one way bearing to the test and it worked perfectly. The EPI purple spring and 1.5 mm...
  • backfiring and popping
    Hey guys I have a 2003 grizzly 660 and it runs great until I run it wide open, around 45 or 50mph it starts popping and cutting out on me... any...
  • Sunk Grizz now engine has rapping sound
    Sunk my Grizz on w-end, didn't have time to shut it off! Drained water, changed oil couple times, no problem starting it but it has a terrible loud... […]