Yamaha Motorcyes . org - Yamaha Motorcycle Information

2009 Yamaha WaveRunners FZR Pictures & Specs


2009 Yamaha WaveRunners FZR Pictures & Specs

Yamaha FZR Specifications

  • Yamaha FZR MSRP:*Starting at $12,599
    Engine Type 4-Cylinder, 4-Stroke
    Bore/Stroke 86 x 78mm
    Displacement 1812cc
    Fuel Regular Unleaded
    Type of Exhaust Wet
    Type of Lubrication Wet Sump
    Cooling Open-Looped, Water
    Starting Electric
    Ignition Direct Ignition
    Compression Ratio 8.6:1
    Carburetor/Injection Electronic Fuel Injection
    Ignition Timing 20° BTDC
    Spark Plug NGK LFR6A
    Pump 155mm Axial Flow
    Transmission Direct Drive from Engine
    Impeller 3-Blade, Stainless Steel
    Length 131.9 in (3.37m)
    Width 48.4 in (1.23m)
    Height 45.7 in (1.16m)
    Dry Weight 807 lb (366lg)
    Fuel Capacity 18.5 gal (70 L)
    Oil Capacity 1.1 gal (4.2 L)
    Vehicle Capacity 2 person/ 353 lb (160 kg)
    Storage Capacity 21.3 gal (80.6 L)
    Hull Material NanoXcel
    Warranty 1 year limited warranty
    Color Metallic Racing Blue

No comments currently exist for this post.
Leave a Reply:




Latest Comments Sponsors
Sponsor Links
link arrows
Yamaha Motorcycle Archives RSS Yamaha ATV Forums
  • 1984 Yamaha ATC Question
    I purchased this Yamaha 200 3 wheeler several months back, it has electric start and shaft drive. Over a few inches from the pull crank I see a black...
  • full throttle.starves out. dies
    I am new here to this site..and have done a lot of research on this site and it's freaking great info cache. I have a 2004 450 quad..and have been...
  • New filter, no start
    2000 blaster, when running without a filter has crazy high idle. I put a new filter o e and it won't start at all now
RSS Yamaha Rhino Forums
  • Axle removal?
    I have new boots on the way. Are the inner CV joint's just held in with a circlip so a tug will remove them? Stacey
  • Low range & reverse
    A few weeks ago I was reading a thread where somebody had dremeled out the reverse and low range to get rid of the dreaded 660 no engage problem, Now...
  • shock bolt?
    Shock bolt? Rear shock the bottom bolt. Has anyone had a problem removing it? I pounded and pounded and pb blaster and still wont come out. Any...
RSS Yamaha Grizzly Forums
  • Oil drain plug torque
    I just did my first oil change on my 2016 grizz and they call for I believe 16ft-lbs for the drain plug. I didn't come anywhere near that with...
  • Nitrous install
    So I've had this nitrous kit sitting on my shelf in the garage for over a year now. Well now that I have a vacation I plan on installing it this...
  • Ricochet Installation Question
    Installed the10 piece Ricochet skid plate kit today on my 2015 Grizz 700. At a bit of a loss here. Everything went fairly well. However, the...